top of page

Maxtech SI8715 Electrical Insulating Liquid Silicone Gel for Electronic Potting

Product Description

SI8715 is two-component transparent self-healing silicone gel, after cured it will become quite elastic material with buffer and self-recovery. Used to isolate moisture and other noxious pollutants from contacting the circuit board, also used as a dielectric of high voltage. The other usage is a stress relief for protecting circuits and components from high temperatures and mechanical stress.


Typical Applications

Used for encapsulation of various modules, semi-conductor, IGBT, automotive ECU module, IC chip, weighing sensor, waterproof connector.


Key Features

  • 1:1 addition type, good adhesive strength and self-healing 
  • High elongation, excellent flexibility for mechanical stress relieving
  • Low oil penetration after cured, good anti-poisoning property
  • Good dielectric in high temperature for high voltage protection 
  • Excellent aging resistance and weatherability 
  • Excellent waterproof, corrosion prevention, moisture-proof and chemical media resistance


Packing Specification

Part A—10 KG/Bucket

Part B10 KG/ Bucket.



Transport &Storage

When stored at or below 25°C in the original unopened containers, this product has a usable life of 12 months from the date of production. A sampling test is necessary for products which exceed shelf life before taking use.

It’s non-dangerous goods, can be transported as normal chemicals, CAUTION leakage during transport.


.Directions for Use

  • Mix Part A and Part B by 1:1 mass ratio, after evenly mixed, pouring directly into the components or modules as per requirements.

    Still the potted component to let out the bubbles. It can be heat cured, about 30mins in 80°C. It needs about 4-5hours cured under room temperature. Require 24 hours to achieve surface without obvious oil layer.

  • Vacuum defoaming can improve the performance of the cured products.
  • Seal the remaining products tightly after use.
  • The low temperature will slow the curing speed; heat curing is recommended.
  • It's hard for SI8715 to cure if contact with sulfur, amine, or Sn


Attention of operation

Keep away from Children

Avoid contact with eyes and skin. If contact with your skin, scrub first with soap water or alcohol, then rinse with water. If contact with your eyes, rinse with plenty of water, and seek medical treatment immediately.

 It is forbidden to build on the surface of the wet substrate.

Electrical Insulating Liquid Silicone Gel for Electronic Potting

10 Kilograms


    VALUE of SI8715



    PART A

    PART B




    Hydrogen polysiloxane


    Visual inspection

    Colorless Liquid

    Colorless Liquid


    25°C, cps




    25°C, g/cm3



    Mixture/mass ratio



    Viscosity of mixture

    25°C, cps


    Operation time

    25°C, min


    Fixture Time

    25°C, hour


    Cure condition


    25°C/24hour, 80°C/30min

    Cured appearance


    Transparent gel

    Needle penetration

    1/10 mm


    Dielectric strength



    Volume resistance

    DC500V, ohm-cm


    Loss factor

    1 MHz


    Dielectric constant

    1 MHz


    Application temperature




    Note:All above data were tested under standardized condition, or tested by further experiments.

bottom of page